Let’s unbox your Adventurer 5M
Today we build. We start by carefully unboxing your Flashforge Adventurer 5M, removing every piece of packaging and protective foam, and getting the printer set up in your workspace. Follow along with the video, then use the written steps and checklist below.Before you open the box
Clear your space
The box is large and heavy. Work on the floor or a sturdy table with room to spread out.
Get scissors ready
You need scissors to cut the tape. Cut carefully, away from your body.
Ask for help if needed
The printer weighs around 13-15 pounds. If lifting is hard, ask someone to assist.
Step-by-step unboxing
1
Cut the tape and open the flaps
The box has two side handles and tape across the top. Lay your scissors flat and apply gentle pressure with one hand while pulling with the other to slice the tape. Work across the center, then each side, until all four top flaps open freely.
2
Remove the paperwork and top foam
On top you will find paper and the user guide - set these aside. Below them are two large white foam inserts. Slide your thumbs under the top edge of each and gently lift them straight out.
3
Lift the printer out of the box
Reach in and grab the printer like a crate, hands on both sides as if grabbing two handles. Lift straight up and set it in your workspace. If it is too heavy, ask for help or gently tip and scoot it out.
4
Store the empty packaging
Put the foam inserts back into the empty box and set it aside. Keep all packaging - you will want it if you ever move or ship the printer.
5
Remove the plastic bag
A blue piece of tape holds the protective bag closed at the top. Peel off the tape, open the bag, and lift the printer up and out of it. Place the plastic in your storage box.
6
Take out the loose components
With the top of the printer facing up (you will see a white tube and a cable up top), reach into the metal braces and remove the packed items one at a time:
- The power cable (goes to the wall)
- The tool package (pliers, screwdriver, glue, and other tools rolled up tightly)
- The filament spool wrapped in plastic (with a silica gel pack to keep it dry)
7
Remove the internal foam - in the right order
There are two foam pieces inside. Remove the blocky rectangular piece first (about 8-10 inches by 4 inches, tucked behind and under the tube). Taking it out first releases the lip on the larger piece.For the large foam block, gently push the extruder bar toward the back of the printer to free the foam’s lip from under the bracket, then lift the foam straight up and out.
8
Remove the front base-plate foam
At the very front, near the FlashForge logo, is a foam rectangle protecting the bed lip. Gently pull it outward so the lip slides out of its cut, then remove it.
Whenever you remove a stray plastic wrapper, sticker, or foam piece, drop it straight into your storage box. Keeping your workspace clean now prevents lost screws and confusion later.
Do a final foam check
Before moving on, double-check that all foam and packing material has been removed. Leftover foam is the number one cause of a failed first calibration.Your printer is fully unboxed and ready for assembly when:
- All tape, stickers, and plastic bags are removed
- Both top foam inserts and both internal foam blocks are out
- The front base-plate foam is removed
- The power cable, tool package, and filament are set aside in your workspace